Microsoft has published a patent application describing replaceable thumbstick modules for gaming controllers, potentially making worn or malfunctioning joysticks easier to replace without disassembling an entire controller. The proposed design uses a single captive screw, an alignment pin and electrical contacts to secure a removable thumbstick assembly inside a compatible device.
The application, titled “Replaceable Input Module,” was filed by Microsoft Technology Licensing on May 8, 2025, and published by the US Patent and Trademark Office on November 12, 2026. Identified as US20260362619A1, the filing outlines a mechanical mounting system intended to keep removable control sticks securely positioned while allowing them to be detached and replaced.
Unlike conventional removable thumbstick caps, which only change the part touched by the player’s thumb, Microsoft’s proposed design involves replacing the underlying joystick module itself, including the mechanism that detects movement.

The patented assembly consists of a housing containing a control stick and a transducer responsible for converting stick movement into electrical signals. A seating protrusion fits into a corresponding opening in the controller, while a locating pin helps align the module during installation.
A fastening screw then secures the assembly against the controller’s internal mounting surface. The design describes angled mating surfaces that help hold the module in position and reduce unwanted movement. The screw is captive, meaning it remains attached to the module rather than becoming a separate loose component during removal.
Microsoft also describes electrical contacts on the underside of the removable assembly. These provide the connection between the joystick module and the controller’s internal electronics, eliminating the need for a permanently soldered connection at that interface.
The filing discusses using redundant electrical contacts to maintain connectivity if an individual contact becomes unreliable. It also describes a module identification signal that could allow compatible hardware to recognize different installed thumbstick assemblies.
The design is particularly relevant to controller repairability. Thumbsticks can develop problems such as inconsistent movement or stick drift over time, and replacing a conventional joystick mechanism often requires opening the controller and working with internal components.
A controller built around Microsoft’s proposed system could instead allow a faulty thumbstick assembly to be removed and replaced as a complete unit. However, the actual convenience of that process would depend on the final controller design, the accessibility of the fastening screw and the availability of replacement modules.
The patent also discusses accommodating different sensing technologies within the removable housing, including potentiometer-based and magnetic position sensors. This suggests the mechanical system is not necessarily restricted to one type of joystick sensor.
Microsoft already offers interchangeable thumbstick caps on certain Xbox controllers, but those accessories do not replace the underlying movement-sensing mechanism. The newly published application addresses a different level of modularity by describing how the complete input assembly could be mechanically secured and electrically connected.
For now, the technology remains a patent proposal rather than an announced Xbox accessory or controller feature. Microsoft has not confirmed that this specific mechanism will appear in a future Xbox Wireless Controller, Elite controller or other commercial product.
The filing also does not establish whether a potential controller using the design would support user-installed Hall-effect or TMR thumbstick upgrades. Although the proposed architecture could accommodate different sensing approaches, no specific retail configuration or launch timetable has been announced.
Microsoft’s application nevertheless provides a detailed look at one approach to making controller thumbsticks more replaceable, with a mounting system designed around secure positioning, electrical connectivity and straightforward module removal.
